PULSE / PULSE ATEX

What type of input should I choose on my meter ?
The PULSE sensor has 2 types of inputs :  "Gas" (pull-up activated) ,  "Other" (pull-up disabled).   The "Gas" type is...
Mon, 16 Nov, 2020 at 10:16 AM
To which terminals should I wire me for the impulse?
The first thing to do is to check whether the pulse output of the meter or meter head is polarised (sometimes for some electricity meters). If the impulse...
Mon, 16 Nov, 2020 at 10:26 AM
To which terminals should I wire me for fraud?
To wire the fraud you must connect the fraud wire to terminal 8 of the PULSE. Refer to the user guide of the PULSE for more details.  Wiring for a 3-...
Mon, 16 Nov, 2020 at 10:28 AM
How do I wire the PULSE if my meter is already connected to a transmitter?
If the meter is already connected to a transmitter other than the PULSE, it is imperative to use a pulse splitter that incorporates galvanic isolation to is...
Mon, 16 Nov, 2020 at 10:16 AM
In which unit does the PULSE count? Does the PULSE count in a specific unit?
The PULSE does not associate a unit with its pulse count. It counts 1 for a pulse generated by the counter or pulse module.  It is therefore necessary ...
Mon, 16 Nov, 2020 at 10:17 AM
Which debounce period (anti-bounce filter) should I choose?
The debounce period filters out parasitic impulses or bounces. It is necessary to know the pulse width generated by the meter head (characteristic given...
Mon, 16 Nov, 2020 at 10:17 AM
Can I simulate impulses to test the correct operation?
It is possible to simulate impulses in a very simple way. Simply connect a push button or create a wire contact between the IMP and GND terminals of the PUL...
Mon, 16 Nov, 2020 at 10:17 AM
How do I adjust my index finger?
Index adjustment is done via the IoT Configurator tool provided by Adeunis (downloadable from https://www.adeunis.com/en/device-management-2/sensor-setup/)....
Mon, 16 Nov, 2020 at 10:30 AM
How do I reset my index?
Index adjustment is done via the IoT Configurator tool provided by Adeunis (downloadable from https://www.adeunis.com/en/device-management-2/sensor-setup/)....
Mon, 16 Nov, 2020 at 10:33 AM
What is the maximum cable length between my meter and the PULSE?
We recommend a maximum cable length of 10 metres between the pulse output of the meter and the PULSE terminal block.  For any other question or if...
Mon, 16 Nov, 2020 at 10:17 AM