The "Flow calculation period" parameter is only useful when using the PULSE in:
- OVERFLOW MONITORING: transmission of an alarm frame if the measured flow rate is higher than an estimated average flow rate.
- LEAK DETECTION: transmission of an information in the 0x30 frame if the rate is lower than an estimated average rate.
This parameter is not used in the most common PULSE operation which is index transmission.
Via the IoT Configurator tool provided by Adeunis (to be downloaded from https://www.adeunis.com/device-management/configuration-des-capteurs/) you can configure the PULSE operating mode (Index acquisition period, frequency of transmission of these acquisitions, addition of redundancy) or switch the sensor to Production Mode.
Once your sensor is connected:
- go to the "Application Configuration" menu,
- then "General Configuration".
For any other question or if the information you searched is missing in the FAQ, please, contact our technical support through the ticketing platform: https://adeunis.freshdesk.com/en/support/tickets/new
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article