FTD
When you want to use the FTD and in order to ensure optimal use, it is necessary to : Ensure that the FTD battery is fully charged to guarantee operati...
Mon, 18 May, 2020 at 5:07 PM
If you are unable to connect your FTD to the IoT Configurator, it is necessary to check : Firmware versions of your FTD > appear on the screen when ...
Mon, 18 May, 2020 at 5:07 PM
Depending on the version of the FTD on hand and the firmware version to be updated it is possible that your FTD can be updated. However, before updatin...
Mon, 18 May, 2020 at 5:20 PM
>>> Read the dedicated article on the "1st STEPS WITH A SENSOR" parts.
Mon, 18 May, 2020 at 5:09 PM
Please consult the following recommendations before making any changes: DEV-EUI: this is the unique identifier of the LoRaWAN device. This identifier ...
Mon, 18 May, 2020 at 5:10 PM
If after powering up the LoRaWAN FTD, the Join Request (JR) is looped without receiving a Join Accept (JA) from the network, you need to : ensure that ...
Mon, 18 May, 2020 at 5:11 PM
For firmware versions prior to 2.0.0 : The network did not receive the uplink and could not downlink to the FTD. This means that the network coverage is i...
Mon, 18 May, 2020 at 5:11 PM
This can only happen with FTDs with firmware versions 2.0.0 or higher: The network did not receive the uplink and could not downlink to the FTD. This me...
Mon, 18 May, 2020 at 5:11 PM
If after several minutes of powering on, the FTD does not display a GPS fix : Check that the GPS is activated -> via the IoT Configurator, from the ...
Mon, 18 May, 2020 at 5:12 PM